Careful consideration must be given to the speaker location
to realize the full frequency range. Ceiling speakers should
be spaced 6 to 8 feet (6 feet for 8-foot ceilings and 8 feet
for 10-foot ceilings and above) apart but no closer than 2
feet to any adjacent wall. Avoid placing speakers in air return
cavities. Some type of protection will be required for
the back of the speaker if blown insulation is used
( you can use the carton box where the speaker was packed in)

Do not install speakers in stud cavities containing
120/240V appliances, within 15 -20 inches of dimmer light
fixtures, security wiring and other control wiring.

After you have determine the speaker locations
We recommend that you use a 16 gauge 2 conductor
cable, for attachment to the speakers.

To begin installation of the speakers, first locate
the area where the wires are installed. At each location,
cut a hole to the dimensions shown for the model being
installed (Mounting Dimensions).
Cut out templates are included with our ceiling speaker
Products. The cutout should be centered in the stud
space opening. Prepare the speaker wiring by stripping off
approximately 3 inches of the outer jacket (care should
be taken so the insulation on the wires inside the jacket
are not damaged) also strip approximately 3/8 inch off the
ends of the two inside conductors. Twist the ends of the
stranded cable so the wires are tight.
You are now ready to install the speaker. Remove
the front grille from the speaker. (Be careful not
to touch the speaker cones in order to prevent any damage).
Attach the speaker cable to the speaker by pressing
down on the red (+) or black (-) tabs and inserting the
red wire in the red terminal and the black wire in the
black terminal. Make sure that none of the
strands from the black and red wires are touching each
other. This can create a short circuit that can damage
your electronics. Index the mounting tabs to make sure
that all tabs will clear the opening. Insert the speaker in
the wall and tighten the tabs with the screws on the front
of the grille. Never over tighten the screws.
After the speaker is mounted, adjustments to
the swivel tweeter (small speaker) can be made by either
directing the sound visually or by using a musical source
to determine the best sound coverage for the listening
area. To position the tweeter, press at the outside edge
of the tweeter cone area .
Reinstall the grill on the speaker.